Être un travailleur IT, est-ce que vous vous souciez encore pour passer le test Certificat IT? Le test examiner les techniques et connaissances professionnelles, donc c'est pas facile à réussir. Pour les candidats qui participent le test à la première fois, une bonne formation est très importante. Pass4Test offre les outils de formation particulier au test et bien proche de test réel, n'hésitez plus d'ajouter la Q&A au panier.
Avec la version plus nouvelle de Q&A Cisco 642-885, réussir le test Cisco 642-885 n'est plus un rêve très loin pour vous. Pass4Test peut vous aider à réaliser ce rêve. Le test simualtion de Pass4Test est bien proche du test réel. Vous aurez l'assurance à réussir le test avec le guide de Pass4Test. Voilà, le succès est juste près de vous.
Le produit de Pass4Test est réputée par une bonne qualité et fiabilité. Vous pouvez télécharger le démo grantuit pour prendre un essai, nons avons la confiance que vous seriez satisfait. Vous n'aurez plus de raison à s'hésiter en face d'un aussi bon produit. Ajoutez notre Q&A au panier, vous aurez une meilleure préparation avant le test.
Dépenser assez de temps et d'argent pour réussir le test Cisco 642-885 ne peut pas vous assurer à passer le test Cisco 642-885 sans aucune doute. Choisissez le Pass4Test, moins d'argent coûtés mais plus sûr pour le succès de test. Dans cette société, le temps est tellement précieux que vous devez choisir un bon site à vous aider. Choisir le Pass4Test symbole le succès dans le future.
Dans ce monde d'informatique, l'industrie IT est suivi par de plus en plus de ges. Dans ce domaine demandant beaucoup de techniques, il faut des Certificat à se preuver les techniques professionnelle. Les Certificats IT sont improtant pour un interviewé pendant un entretien. C'est pas facile à passer le test Cisco 642-885, donc c'est pourquoi beaucoup de professionnels qui choisissent ce Certificat pour se preuver.
Code d'Examen: 642-885
Nom d'Examen: Cisco (Deploying Cisco Service Provider Advanced Routing (SPADVOUTE))
Questions et réponses: 80 Q&As
642-885 Démo gratuit à télécharger: http://www.pass4test.fr/642-885.html
NO.1 Refer to the topology diagram shown in the exhibit and the partial configurations shown below.
Once the attack from 209.165.201.144/28 to 209.165.202.128/28 has been detected, which additional
configurations are required on the P1 IOS-XR router to implement source-based remote-triggered black
hole filtering?
! router bgp 123 address-family ipv4 unicast redistribute static route-policy test !
A. router static address-family ipv4 unicast 209.165.202.128/28 null0 tag 666 192.0.2.1/32 null0 tag 667 !
route-policy test if tag is 666 then set next-hop 192.0.2.1 endif if tag is 667 then set community (no-export)
endif end-policy !
B. router static address-family ipv4 unicast 209.165.201.144/28 null0 tag 666 192.0.2.1/32 null0 tag 667 !
route-policy test if tag is 666 then set next-hop 192.0.2.1 endif if tag is 667 then set community (no-export)
endif end-policy !
C. router static address-family ipv4 unicast 209.165.201.144/28 null0 tag 666 192.0.2.1/32 null0 !
route-policy test if tag is 666 then set next-hop 192.0.2.1 set community (no-export) endif end-policy
D. router static address-family ipv4 unicast 209.165.202.128/28 null0 tag 666 192.0.2.1/32 null0 !
route-policy test if tag is 666 then set next-hop 192.0.2.1 set community (no-export) endif end-policy !
Answer: C
Cisco 642-885 642-885 certification 642-885
NO.2 Refer to the exhibit.
Given the partial BGP configuration, which configuration correctly completes the Cisco IOS-XR route
reflector configuration where both the 1.1.1.1 and 2.2.2.2 routers are the clients and the
3.3.3.3 router is a non-client IBGP peer?
A. neighbor 1.1.1.1 remote-as 65123 route-reflector-client neighbor 2.2.2.2 remote-as 65123
route-reflector-client neighbor 3.3.3.3 remote-as 65123
B. neighbor 1.1.1.1 address-family ipv4 unicast remote-as 65123 route-reflector-client neighbor 2.2.2.2
address-family ipv4 unicast remote-as 65123 route-reflector-client neighbor 3.3.3.3 address-family ipv4
unicast remote-as 65123
C. neighbor 1.1.1.1 remote-as 65123 address-family ipv4 unicast route-reflector-client neighbor 2.2.2.2
remote-as 65123 address-family ipv4 unicast route-reflector-client neighbor 3.3.3.3 remote-as 65123
D. neighbor 1.1.1.1 remote-as 65123 neighbor 1.1.1.1 route-reflector-client neighbor 2.2.2.2 remote-as
65123 neighbor 2.2.2.2 route-reflector-client neighbor 3.3.3.3 remote-as 65123
Answer: C
certification Cisco 642-885 examen 642-885 642-885 certification 642-885
NO.3 When a BGP route reflector receives an IBGP update from a non-client IBGP peer, the route reflector
will then forward the IBGP updates to which other router(s).?
A. To the other clients only
B. To the EBGP peers only
C. To the EBGP peers and other clients only
D. To the EBGP peers and other clients and non-clients
Answer: C
Cisco 642-885 642-885 examen
NO.4 When implementing source-based remote-triggered black hole filtering, which two configurations are
required on the edge routers that are not the signaling router? (Choose two.)
A. A static route to a prefix that is not used in the network with a next hop set to the Null0 interface
B. A static route pointing to the IP address of the attacker
C. uRPF on all external facing interfaces at the edge routers
D. Redistribution into BGP of the static route that points to the IP address of the attacker
E. A route policy to set the redistributed static routes with the no-export BGP community
Answer: A,C
Cisco examen 642-885 642-885 examen certification 642-885
NO.5 Which three methods can be used to reduce the full-mesh IBGP requirement in a service provider core
network? (Choose three.)
A. implement route reflectors
B. enable multi-protocol BGP sessions between all the PE routers
C. implement confederations
D. implement MPLS (LDP) in the core network on all the PE and P routers
E. enable BGP synchronization
F. disable the IBGP split-horizon rule
Answer: A,C,D
certification Cisco 642-885 642-885
NO.6 In Cisco IOS-XR, the ttl-security command is configured under which configuration mode?
A. RP/0/RSP0/CPU0:P2(config)#
B. RP/0/RSP0/CPU0:P2(config-bgp)#
C. RP/0/RSP0/CPU0:P2(config-bgp-nbr)#
D. RP/0/RSP0/CPU0:P2(config-bgp-af)#
E. RP/0/RSP0/CPU0:P2(config-bgp-nbr-af)#
Answer: C
Cisco 642-885 642-885 certification 642-885 certification 642-885 certification 642-885
NO.7 Which two BGP mechanisms are used to prevent routing loops when using a design with redundant
route reflectors? (Choose two.)
A. Cluster-list
B. AS-Path
C. Originator ID
D. Community
E. Origin
Answer: A,C
certification Cisco 642-885 certification 642-885 642-885
NO.8 In Cisco IOS-XR, the maximum-prefix command, to control the number of prefixes that can be installed
from a BGP neighbor, is configured under which configuration mode?
A. RP/0/RSP0/CPU0:P2(config-bgp)#
B. RP/0/RSP0/CPU0:P2(config-bgp-af)#
C. RP/0/RSP0/CPU0:P2(config-bgp-nbr)#
D. RP/0/RSP0/CPU0:P2(config-bgp-nbr-af)#
Answer: D
Cisco examen 642-885 642-885 642-885 642-885
NO.9 Referring to the topology diagram show in the exhibit,
which three statements are correct regarding the BGP routing updates? (Choose three.)
A. The EBGP routing updates received by R1 from R5 will be propagated to the R2, R4, and R7 routers
B. The EBGP routing updates received by R3 from R6 will be propagated to the R2 and R4 routers
C. The EBGP routing updates received by R1 from R5 will be propagated to the R2 and R4 routers
D. The IBGP routing updates received by R3 from R2 will be propagated to the R6 router
E. The IBGP routing updates received by R2 from R1 will be propagated to the R3 router
F. The IBGP routing updates received by R1 from R4 will be propagated to the R5, R7, and R2 routers
Answer: A,B,D
Cisco examen 642-885 certification 642-885 642-885 examen
NO.10 Which two statements correctly describe the BGP ttl-security feature? (Choose two.)
A. This feature protects the BGP processes from CPU utilization-based attacks from EBGP neighbors
which can be multiple hops away
B. This feature prevents IBGP sessions with non-directly connected IBGP neighbors
C. This feature will cause the EBGP updates from the router to be sent using a TTL of 1
D. This feature needs to be configured on each participating BGP router
E. This feature is used together with the ebgp-multihop command
Answer: A,D
Cisco certification 642-885 642-885
Vous pouvez tout d'abord télécharger le démo Cisco 642-885 gratuit dans le site Pass4Test. Une fois que vous décidez à choisir le Pass4Test, Pass4Test va faire tous efforts à vous permettre de réussir le test. Si malheureusement, vous ne passez pas le test, nous allons rendre tout votre argent.
没有评论:
发表评论